Gasboy SCII CPU PCB Manuel d'utilisateur télécharger pdf

C35381 Rev. 6253 1

SITE CONTROLLER II CPU INSTRUCTION SHEET

Use the following kits (C07047 and C07048) to replace the CPU board in a site controller. Each kit contains the following:

•

Site Controller II CPU Instruction Sheet, C35381

•

CPU board assembly C05852 (kit C07047) or C05328 (kit C07048)

•

PAL replacement kit containing CSGEN2a or CSGEN3

1. Before installing the new CPU board, make sure

ALL

data has been polled and/or backed up. If the system is a site

controller II on a bank network, make sure a settlement has been done and completed without failure. Turn off power

and unplug the site controller.

2. Remove the four Phillips screws from the sides of the site controller and remove the cover.

3. Disconnect all cables going to the CPU board (top board), making note of which cable goes to which connector.

Remove the Phillips screws that secure the site controller CPU board and carefully remove the board.

4. Refer to the chart at right and insert the proper

CSGEN chip on the memory board. Refer to drawing

below for placement of CSGEN PAL. If memory board

does not match drawing, do not change PAL.

5. Set the jumpers on the CPU board to match the site's configuration.

6. Reassemble the site controller. Plug in the site controller and turn on power. Verify the site is working correctly.

1 2 3 4 5

Page 1

C35381 Rev. 6253 1SITE CONTROLLER II CPU INSTRUCTION SHEETUse the following kits (C07047 and C07048) to replace the CPU board in a site controller.

2 C35381 Rev. 6253SITE CONTROLLER II CPU PCB - C05852 OR CR5852NOTE: C05852/CR5852 CPU PCB requires operating system version 2.0C or above, new memo

Page 3

C35381 Rev. 6253 3K23-K37 CPU BOARD JUMPERS - C05852 ONLYK1 & K2, PORT 1 & PORT 3 CONFIGURATION JUMPERS -C05852/CR5852 OR C05328/CR5328CPU P

4 C35381 Rev. 6253DSW1-7 & DWS1-8 Mode Set SwitchesDSW2 - Baud RatesK23-K36 CPU BOARD JUMPERS - C05328 ONLY

Page 5

C35381 Rev. 6253 5SITE CONTROLLER II CPU PCB - C05328 OR CR5328JUMPER - C05328/CR5328 ONLY

Pas de commentaire

Gasboy SCII CPU PCB Manuel d'utilisateur