Gasboy 9800A Manuel d'utilisateur télécharger pdf (Page 5)

MDE-4863 Gasboy® 9800A or 2600A Pump Interface Kits Installation Instructions · October 2009 Page 5

Installation of the 9800A/2600A Pump Interface Kit

Installing these kits involves DC wiring to the Fuel Management System. Read the MDE-4341

Series 9800A/9800Q Pump and Dispenser Installation/Operation Manual and your Fuel

Management System Installation Manual before you proceed. Also refer to

Figure 7 on

page 10 and Figure 8 on page 11.

To install the Pump Interface Kits, proceed as follows:

1 Turn off the Circuit Breakers that supply power to the MICRO, LIGHTS, and FEED.

2 Unlock and remove the front panel.

Figure 1: Unlocking the Front Panel

Unlock

3 Remove the two bolts located over the tabs of the Bezel Assembly. Lift the Bezel Assembly

upwards and out to remove.

Figure 2: Removing the Bolts on the Front Panel

Bolts

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Gasboy 9800A Manuel d'utilisateur Page 5