Gasboy CFN Series Unitec PC Interface Manuel d'utilisateur télécharger pdf (Page 12)

Cable Connections and Software Installation Software Installation

Page 8 MDE-4695 CFN Series Unitec® PC Interface for Site Controller III Version 3.6 and Later · July 2010

When you start SC III, it will automatically start the interface program on the selected ports.

The session will be titled “Unitec Car Wash Session on COM x”, where “x” is the selected

COM port. The parameter file is C:SC3\XBIN\UNITEC.A0x, where “x” is the selected COM

port. The file can be edited with any text editor.

Verifying the Installation

To verify the software installation, proceed as follows:

1 Start the SC III program.

2 If the Car Wash does not start communicating, switch to the “Unitec Car Wash Session”

window and press 1. If there are communication problems, error messages will be displayed

on the screen.

Note: A message is displayed at least once every 10 seconds.

3 Press 3 to view all messages, regardless of the installation status. Refer to “Troubleshooting”

on page 13.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Gasboy CFN Series Unitec PC Interface Manuel d'utilisateur Page 12