Gasboy Site Controller II CPU Manuel d'utilisateur télécharger pdf (Page 14)

Upgrading Installing a New Memory Board

Page 10 MDE-4504 Site Controller II CPU/Memory Board/Program Upgrade Instructions · August 2005

DSW2 - Baud Rates

Installing a New Memory Board

To install a new memory board, proceed as follows:

1 From the base of the Site Controller, remove the two Phillips screws securing the old memory

board and remove the board.

2 Remove the standoffs from the old memory board, and install them in the same locations on

the new memory board.

3 Ensure that there are no standoffs in the last two mounting holes, on the back of the memory

board.

4 Install C09622 nylon standoff, and C04126 standoff in the rear left mounting hole. Refer to

Figure

3-3.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Pas de commentaire

Gasboy Site Controller II CPU Manuel d'utilisateur Page 14